Products

IPTV/MATV

MOD90S Multistandard double sideband audio/video stereo A2 modulator with Crystal PLL synthesizer to set up the output frequency. The VHF and UHF frequency band and the high flexibility with multi-standard selection enable it to be used in many different installations.



FINAL PUSH-PULL AMPLIFIERS – KW33C Broadband launch amplifier with push-pull technology allows the amplification of the whole 47-862MHz band, including the S band. With one input and one output, the KW series are used to amplify the signal from KF filters or other modules (receivers, modulators, etc).

 

POWER SUPPLIES – KP35 The power supply units contain switching technology to ensure the best performance and reliability. They are protected from both short and long term overloads. Isolation: class II. Operating temperature: -10°C to +55°C.




AMP9762 - AMP9762B Push-pull amplifiers with excellent performance in band linearity and flatness. This unit conforms to standard EN60065 and is manufactured in die cast housing with F connectors and direct connection to the mains. Shielding factor to standard EN50083-2. It is possible to equalise cable losses from 0 to 20dB. Mains voltage 220-240V~ , 50-60Hz. Power consumption 3.5W. Terrestrial line amplifiers with return path. To be used as the final amplifier before wall outlets. Normally used to amplify signals in small distribution networks. These amplifiers can be used at the output of an optical link. All the adjustments are internally located under the die cast cover to prevent unauthorised access. The die cast cover is secured with safety screws. For installation, supports are available (item MBX0001 see page 64) that leave a space of 19mm between the amplifier and the wall, allowing room for cables or the amplifier to be mounted in different positions. Packaging 1 pc. • Gain and slope can be adjusted • Passive or active return path, switchable by the installer


POWER SUPPLIES – KP35 The power supply units contain switching technology to ensure the best performance and reliability. They are protected from both short and long term overloads. Isolation: class II. Operating temperature: -10°C to +55°C.




AMP5121 Distribution amplifiers to be used in HFC (hybrid fibre cable) networks. • High output level and low power consumption using GaAs FET hybrid technology • Gain and tilt adjustment using attenuators • Integrated active or passive return path, selected by a switch • Mains or line powered with switch mode power supply • Die-cast aluminium housing meeting IP65 protection • 5A AC power pass through to any terminal and 10A external AC input terminal • Excellent surge and transient protection



2, 3 and 4 WAY RF SPLITTER









PROGRAMMING UNIT - TPE Programming unit with numeric keypad and graphic display. Enables the programming of all new modules in the K Series and Headline range and also the original K Series modules.





MODULATORS – SIG7282 Audio video modulators, double conversion, double saw filter and tracking filter built in. One modulator covers the whole 47-862MHz band and a very high C/N ratio in the band allows the distribution of more than 80 channels. Available in PAL B/G mono (SIG7282), PAL B/G stereo (SIG7282S) and multistandard (SIG7281).